A4 Audi
+ Running gear
+ Regular servicing
- Engines
Power steps
Engine signs
Technology of the engine, maintenance and repair
Lubrication system
Exhaust ventilation of a case
Visual control of the engine
Engine service life
Nominal and maximum frequency of turns
Restriction of number of turns
Measurement of pressure of compression
The help at malfunctions
Hydropushers
Works on a gear belt
The help at malfunction
Installation and dismantle of a head of the block of cylinders
Installation and dismantle of the engine
+ Turbo-supercharging
+ System of an exhaust
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and channels of absorption
+ System of injection
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ System of ignition
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
+ body Details
+ Salon
Search of malfunctions
Technical characteristics
|
Installation and dismantle of the engine
|
|
In a workshop the engine is dismantled by means of such lifting device. For these purposes the head of the block of cylinders has fixing eyes to which chains or cables can be certainly attached. Before it is taken out, the frontal part of the car has to be dismantled and all shtekerny and screw connections are disconnected. |
|
|
On the dismantled engine the so-called intercepting device (1) which is combined with an arm (2) transmissions is visible. The sense of it consists in propping up a transmission which at the dismantled engine differently could fail down. Certainly, the same effect can achieve if to prop up it from below. |
The description of dismantle of engines of all models would go beyond opportunities of this management. Here only some essential moments concerning this subject are given:
|
|
- The engine rises without transmission up. For this purpose you need a polyspast which you could suspend reliably at sufficient height. Also "previously loaded assistant" is useful.
- Before direct dismantle remove all disturbing car details: lower facing of the engine, case of the air filter, and also frontal part of the car assembled. If is, dismantle the viscous fan.
- As in Audi A4 the set of electric wires and vacuum hoses is established, you have to designate first of all all these wires and hoses in order that then it is correct to connect them in the right place.
- Before an accumulator detachment you have to be convinced that have a code against theft of the radio receiver.
- Disconnect the accumulator only at the switched-off ignition, differently it is possible to damage control units.
- Before a final detachment of the engine it is necessary to prop up a transmission or to raise it together with even the installed engine a little. For these purposes in a workshop the special tool which rests against fixing edges of wings is used.
- The engine has an eye for suspension into which the lifting device can be inserted. Track reliability of fastening.
|
|
Inhaling moments
|
Details
|
The inhaling moment in Nanometer
|
| All bolts and nuts |
M6
M8
M10
M12
|
10
20
45
60
|
| Reception pipe on an exhaust knee |
M8
|
25
|
| The compressor of climatic installation at an arm |
M8
|
25
|
| The torque converter at a capture guard |
M8
|
35
|
| Engine support in a fastening place to the engine |
M10
|
45
|
| Viscous coupling at an arm |
M10
|
45
|
| Servonasos at an arm |
M8
|
25
|
| The generator at a suspension bracket |
M8
|
35
|
|
|