Audi A4

since 1994 release

Repair and operation of the car

A4 Audi
+ Running gear
+ Regular servicing
+ Engines
+ Turbo-supercharging
+ System of an exhaust
+ Cooling system
+ Fuel tank and fuel pump
+ Air filter and channels of absorption
+ System of injection
+ Coupling
+ Transmission and main transfer
+ Suspension bracket of wheels and steering
+ Brakes
+ Wheels and tires
+ Electrotechnical equipment
+ System of ignition
+ Lighting
+ Alarm equipment
+ Tools and devices
+ Heating and ventilation
- Body details
   Front bumper
   Damages to result of accidents
   Frontal part of the car
   Lateral levels
   Dismantling of doors
   Mirror of the external review
   Trunk lid
   Rear bumper
   Sliding/removable roof
   Check of a corrosion-resistant coating of the bottom
   Clearing of openings for a water drain
+ Salon
Search of malfunctions
Technical characteristics

Rear bumper


For dismantle of a rear bumper it is necessary to weaken on the right and left side of the car on two screws with crosswise heads (1 and 2).


  1. Cast away a floor covering of a luggage carrier.
  2. Unscrew in a luggage carrier on the right and at the left on two bolts with six-sided heads.
  3. Take out lateral faces of a bumper from arms on a body. For this purpose strongly press a bumper sideways down and at the same time pull it for the upper edge from a body.
  4. Wring out a bumper for both ends over wheel niches and remove back.
  5. At installation of a bumper insert back fastenings in the beginning.
  6. In the beginning insert lateral faces of a bumper into an arm on a body bottom edge. Then press lateral faces of a bumper sideways up to that time until the arm enters a groove.
  7. Then level a bumper and screw up bolts.

 Council: Arms of a rear bumper are executed at the same time as shock-proof shock-absorbers – they are deformed at collision and protect structure of a body.